Fluke DSX-8000 - How to Do an OTDR Test

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
334
How to Do an OTDR Test
Figure 138 shows the equipment for OTDR tests.
1 Make sure that the home screen shows the correct settings for
the job.
2 Set up the launch compensation function. See page 322.
3 Clean and inspect the connectors on the launch and tail cords
and the fiber to be tested.
4 Connect the tester to the link as shown in Figure 139, 140, or
141.
5 Tap TEST or press .
Note
The tester shows a warning if there is an optical
signal on the fiber.
Figure 138. Equipment for OTDR Tests
GPU31.EPS
 Main tester with OTDR module
installed
 Launch and tail cords (match the
fiber to be tested)
 FI-1000 video probe with USB
connector
 Fiber cleaning supplies
 AC adapter with line cord
(optional)
A
B
C
E
D