Chapter 20: Maintenance
Traceable Calibration Period
597
GPU203.EPS
Figure 212. How to Replace the DSX-PLA004 Adapter’s Tip and Latch
Traceable Calibration Period
To make sure that the modules operate within the published
specifications for accuracy, have them calibrated at an Authorized
Fluke Networks Service Center every 12 months. To get
information on factory calibration, contact an authorized Fluke
Networks Service Center.
To see when the tester last received a factory calibration, tap the
TOOLS icon on the home screen, then tap Version Information.
Note
When you send modules to a Service Center, it is
typically not necessary to also send the main and
remote testers.
Hole
WCaution
Do not lose
the washer.
Pin
Latch
Tip
WCaution
Do not break
the pin.
To Next Page
Loading...
