Fluke DSX-8000 - Settings for Twisted Pair Tests

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
84
Settings for Twisted Pair Tests
Table 3 gives descriptions of the settings for twisted pair tests. To
set up a project, which includes the settings in Table 3, cable IDs,
and operator names, see Chapter 17.
To set up a twisted pair test
1 On the home screen, tap the test setup panel.
2 On the CHANGE TEST screen, select a twisted pair test to
change, then tap EDIT.
Or to set up a new twisted pair test, tap NEW TEST. If no module
is installed, the MODULE screen shows. Tap the correct copper
module.
3 On the TEST SETUP screen, tap the panels to change settings
for the test. See Table 3.
4 On the TEST SETUP screen, tap SAVE when your test setup is
completed.
5 On the CHANGE TEST screen, make sure the button next to
the test is selected, then tap USE SELECTED.
Table 3. Settings for Twisted Pair Tests
Setting Description
Module Select DSX-8000 CableAnalyzer or DSX-5000
CableAnalyzer. See 25 on page 77.
Cable Type Select a cable type that is correct for the type you will
test. To see a different group of cable types, tap MORE,
then tap a group. To make a custom cable type, select
Custom in the Cable Groups list. See Chapter 19 for
details.