Fluke DSX-8000 - When You Cannot Sync a Deleted Project; Change the Network Settings

Chapter 18: Sync Projects with LinkWare
™
Live
When You Cannot Sync a Deleted Project
563
When You Cannot Sync a Deleted Project
When you delete a project in LinkWare Live, it goes into the
recycle bin. If you synced the project before it was deleted, then
try to sync it again, the tester shows a message to tell you that
you cannot sync a deleted project. You will see this message even
if you rename the project on the tester because LinkWare Live
gives each project a unique, hidden ID that never changes, and
uses this ID to identify projects. If it is necessary to sync the
project, go to the LinkWare Live recycle bin and restore the
project.
If a project in the LinkWare Live recycle bin has never been
synced, and you create a project with the same name on the
tester then sync the project, LinkWare Live shows it as a new,
active project and gives it a unique ID.
Change the Network Settings
It is not usually necessary to change the wired or Wi-Fi network
settings before you try to make a connection. But for example if
you must use static addressing, you can get to the settings on the
NETWORK screen.
To get to the network settings
On the home screen, tap TOOLS, then tap Network, then tap the
Wired or Wi-Fi panel.
To test the settings
Tap CONNECT on the WI-FI PORT or WIRED PORT screen.