Fluke DSX-8000 - AC Adapter and Battery

Chapter 1: Get Acquainted
AC Adapter and Battery
17
LOW BATTERY LED comes on when the battery is low. The LEDs
also have these functions:
 Battery gauge (see Figure 3 on page 20)
 Volume indicator for the TALK function
 Progress indicator for software updates
 Bay for modules, such as the DSX CableAnalyzer, CertiFiber Pro,
or OptiFiber Pro modules.
 : Starts a test.
 : Power button. Versiv 2: The LED in the button shows the
status of the battery charging process. See Table 2 on
page 18.
 : Press  to use the headset to speak to the person at
the other end of the link. Press again to adjust the volume. To
turn off the talk function, hold down .
 Connector for the AC adapter. Versiv: The LED is red when the
battery charges, and green when the battery is fully charged.
The LED is yellow if the battery will not charge. See “Charge the
Battery” on page 18.
 Micro USB port: This USB port lets you connect the tester to a PC
so you can install software updates in the tester.
 Headset jack. See “How to Use the Talk Function” for the DSX-
CableAnalyzer on page 157 or for the CertiFiber Pro OLTS on
page 293.
AC Adapter and Battery
You can use the ac adapter (model PWR-SPLY-30W) or the lithium
ion battery (model VERSIV-BATTERY) to supply power to the
tester.
To remove the battery, see “Remove the Battery” on page 595.