Versiv Series Cabling Certification Product Family
Technical Reference Handbook
60
Step 7: Look at the Results
The tester shows the SmartLoop results in three formats (Figure
19):
EventMap: Shows a diagram of the events on the fiber, the
fiber length, and the overall loss of the fiber.
Use this screen to quickly locate connectors and faults on the
fiber. To see details for an event, tap the event on the map, then
tap the information window for the event.
Tap this button to see the results for the other fiber (A or B).
Tap this button to see results from each direction (End 1 or
End 2) or the averaged results (
).
Touch for 3 seconds to see a summary of the results from
ends 1 and 2 on fibers A and B. To see the EventMap for a result
in the list, tap the result.
TABLE: Shows a table of the events on the fiber shown on the
EventMap.
Use this screen to quickly see measurements for all events and
see the types of events that are on the fiber. The table includes
the distance to the event, the loss of the event, the size of the
reflection from the event, the type of the event, and a pass/fail
status. To see details for an event, tap the event in the table.
TRACE: Shows the OTDR trace for the fiber shown on the
EventMap.
Use this screen to examine events and make other
measurements.
Note
The TRACE tab does not show when you select
averaged results on the EventMap screen.
To Next Page
Loading...
