Contents
xv
Step 4: Make ID Sets for Twisted Pair and
Fiber Cabling ............................................................522
To see the CABLE ID SETUP screen ....................522
To make a cable ID set for tests on
twisted pair cabling ...........................................522
To make a cable ID set for tests on fiber
cabling ................................................................524
Step 5: Give Names to the Ends of the
Fiber for OTDR Tests ................................................530
Step 6: Turn on the Auto Save Function .................531
Tutorial: How to Use a Project for Tests with a
CableAnalyzer Module ...................................................532
Step 1: Select a Project .............................................532
Step 2: Select a Test for Twisted Pair Cable ............533
Step 3: Do an Autotest .............................................534
Step 4: Monitor the Status of Your Project ............534
Tutorial: How to Use a Project for Tests with
OptiFiber Pro and CertiFiber Pro Modules ....................535
Step 1: Select a Project .............................................537
Step 2: Select an OTDR Test .....................................537
Step 3: Select the Correct ID and Fiber End if
Necessary ..................................................................537
Step 4: Do OTDR Tests on End 1 of the Link............537
Step 5: Do OTDR Tests on End 2 of the Link............538
Step 6: Add Results from a Loss/Length Test ..........539
Step 7: Monitor the Status of Your Project ............541
How to Change Settings as You Use a Project ..............541
To Change the ID .....................................................541
To use a different, unused ID from
an ID set that has a first and last ID ..................542
To use an ID you used before ...........................542
To Next Page
Loading...
