Chapter 8: Inspect Fiber Endfaces
Connectors, Keys, and LEDs
217
LCD display with touchscreen.
Blank module included with the FI-7000 kit. Keep the module
installed to give protection to the module connectors.
You can use the FiberInspector function with any module
installed and with no module installed.
Micro USB port: This USB port lets you connect the tester to a PC
so you can upload test results to the PC and install software
updates in the tester.
Type A USB port: This USB host port lets you connect the FI-1000
video probe to the tester and save test results on a USB flash
drive. On a Versiv main tester, this port lets you connect a Wi-Fi
adapter for access to Fluke Networks cloud services. (Versiv 2
testers have an internal Wi-Fi radio.)
Headset jack.
: Starts a test. To start a test, you can also tap TEST on the
display.
Power button. Versiv 2: The LED in the power button shows the
status of the battery charging process. See Table Table 2 on
page 18.
: Press to go to the home screen.
Connector for the AC adapter. Versiv: The LED is red when the
battery charges, and green when the battery is fully charged.
The LED is yellow if the battery will not charge. See “Charge the
Battery” on page 18.
RJ45 connector: Lets you connect to a network for access to Fluke
Networks cloud services.
Removable tip for different types of connectors.
Dial for focus adjustment.
The button starts the FiberInspector test and switches the probe
between still and live modes.
To Next Page
Loading...
