Chapter 8: Inspect Fiber Endfaces
The Home Screen for FiberInspector Tests
219
Shows a summary of the test results in the project:
: The number of tests that passed.
: The number of tests that failed.
The test setup panel shows the settings the tester will use
when you tap TEST or press .
To change these settings, tap the panel.
Note
You can set up tests for any module that the
tester can use, even when no module is attached.
Next ID: The Next ID panel shows the ID that the tester gives
to the next test results you save.
Tap Next ID to do these tasks:
Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
Turn Auto Save on or off.
Select End 1 or End 2 for OTDR and FiberInspector tests.
Enter a name for End 1 and End 2.
Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names. For each operator you
can also enter the email address that the operator will use as an
ID to sign in to LinkWare Live.
TOOLS: The TOOLS menu lets you set up the compensation
function for the launch/tail cords, use tools such as the real-
time trace and the FiberInspector test, see the status of the
tester, and set user preferences such as the language and the
display brightness.
To Next Page
Loading...
