Chapter 9: Certify Fiber Cabling
CertiFiber Pro Connectors, Keys, and LEDs
235
The LED below the output port is red when the port transmits
1310 nm and green for 1550 nm.
WCaution
Do not connect APC (angled physical contact)
connectors to the output or input ports. An APC
connector can damage the UPC fiber endface in the
ports.
Input port with removable connector adapter and dust cap. This
port receives optical signals for loss, length, and power
measurements.
Multimode output port with removable connector adapter and
dust cap. This port transmits optical signals for loss and length
measurements.
The LED below the output port is red when the port transmits
850 nm and green for 1300 nm.
Universal fiber connector (with dust cap) for the visual fault
locator. The connector accepts 2.5 mm ferrules. The LED below
the connector shows the locator’s mode. See Chapter 14.
Button to manually control the output ports ( and ) and the
visual fault locator (
).
Micro USB port: This USB port lets you connect the tester to a PC
so you can upload test results to the PC and install software
updates in the tester.
Type A USB port: This USB host port lets you save test results on a
USB flash drive and connect the FI-1000 video probe to the tester.
On a Versiv main tester, this port lets you connect a Wi-Fi adapter
for access to Fluke Networks cloud services. (Versiv 2 testers have
an internal Wi-Fi radio.)
Headset jack. See “How to Use the Talk Function” on page 293.
: Starts a test. To start a test, you can also tap TEST on the
display.
To Next Page
Loading...
