Versiv Series Cabling Certification Product Family
Technical Reference Handbook
238
WCaution
Do not connect APC connectors to the output or
input ports. An APC connector can damage the UPC
fiber endface in the ports.
Input port with removable connector adapter and dust cap. This
port receives optical signals for loss, length, and power
measurements.
Multimode output port with removable connector adapter and
dust cap. This port transmits optical signals for loss and length
measurements.
The LED below the output port is red when the port transmits
850 nm and green for 1300 nm.
Universal fiber connector (with dust cap) for the visual fault
locator. The connector accepts 2.5 mm ferrules. The LED below
the connector shows the locator’s mode. See Chapter 14.
Button to manually control the output ports ( and ) and the
visual fault locator (
).
Micro USB port: This USB port lets you connect the tester to a PC
so you can install software updates in the tester.
Headset jack. See “How to Use the Talk Function” on page 293.
: Starts a test.
: Power key
: Press to use the headset to speak to the person at
the other end of the link. Press again to adjust the volume. To
turn off the talk function, hold down .
Connector for the AC adapter. The LED is red when the battery
charges, and green when the battery is fully charged. The LED is
yellow if the battery will not charge. See “Charge the Battery”
on page 18.
To Next Page
Loading...
