Chapter 9: Certify Fiber Cabling
The Home Screen for CertiFiber Pro Modules
243
RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
SYNC: To upload results to LinkWare Live, tap SYNC. See Chapter
18.
TEST: Tap TEST to do the test shown in the test setup panel.
The percentage of the tests in the project that are completed.
The tester uses the number of available IDs to calculate this
percentage. See Figure 198 on page 526. % Tested does not
show if your project contains only a Next ID list. See “To Make ID
Sets with International Characters” on page 550 for more
information about the Next ID list.
The type of module attached to the tester.
This icon shows when the input and output ports on the
tester’s CertiFiber Pro module are connected to the ports on the
remote’s CertiFiber Pro module, the remote tester is turned on,
and Smart Remote or Loopback mode is selected.
The asset management icon shows when the owner of a
LinkWare Live account has enabled the asset management
service for the tester. See “About the Asset Management
Service” on page 566.
This icon shows when the talk function is on. To use the talk
function. See “How to Use the Talk Function” on page 293.
To Next Page
Loading...
