Fluke DSX-8000 - Page 293

Chapter 9: Certify Fiber Cabling
Loss/Length Settings for Limits that Calculate a Loss Limit
257
GPU140.EPS
Figure 108. Screen to Set the Number of Connectors,
Splices, and Jumpers
 Splices: Enter the number of splices that are in each path of the
link.
 Jumper Reference: Enter the number of jumpers you will use in
each fiber path when you set the reference. The dotted lines in
the diagram on the screen show you which parts of the link are
included in the test results. See Reference Method on page 255.
 The dotted lines show you which parts of the link are included in
the test results.
D
A
C
H
G
E
B
F