Chapter 9: Certify Fiber Cabling
Autotest in Smart Remote Mode
271
GPU161.EPS
Figure 114. CHANGE ID Screen for Smart Remote Mode
Input Fiber ID and Output Fiber ID show the IDs for the fibers
connected to the testers INPUT and OUTPUT ports at the end of
the test. The Input Fiber ID follows the last Output Fiber ID you
used. To see the input or output fiber IDs that have not been
tested or to change the input ID, tap the Input Fiber ID window.
To select or edit an ID set or to make a new ID set, tap CHANGE
CABLE IDs.
To swap the input and output fiber IDs, tap . The tester uses
subsequent IDs from the list or sequence in descending order.
To Next Page
Loading...
