Versiv Series Cabling Certification Product Family
Technical Reference Handbook
296
Figure 124. Equipment for Power Meter Measurements
To monitor power
1 Clean and inspect the tester’s input port and the connectors
on the source and test reference cord.
2 Connect the tester to the source, as shown in Figure 125.
3 Turn on the source. On a CertiFiber Pro module, hold down
the button adjacent to the VFL port for 3 seconds.
4 On the home screen, tap TOOLS, then tap Power Meter /
Light Source.
5 The default mode for the power meter is Auto CertiFiber Pro.
If the source is not a CertiFiber Pro tester, tap to select the
correct mode.
Figure 126 shows the power meter and its controls.
GPU137.EPS
Main tester with CertiFiber Pro
module installed
One test reference cord
Fiber cleaning supplies
FI-1000 video probe with USB
connector
AC adapter with line cords
(optional)
To Next Page
Loading...
