Versiv Series Cabling Certification Product Family
Technical Reference Handbook
306
Visual fault locator port and protective cap. The LED in front
of the port turns on when the port emits an optical signal.
Button that controls the VFL.
Micro USB port: This USB port lets you connect the tester to a
PC so you can upload test results to the PC and install
software updates in the tester.
Type A USB port: This USB host port lets you save test results
on a USB flash drive and connect the FI-1000 video probe to the
tester. On a Versiv main tester, this port lets you connect a Wi-Fi
adapter for access to Fluke Networks cloud services. (Versiv 2
testers have an internal Wi-Fi radio.)
Headset jack.
: Starts a test. To start a test, you can also tap TEST on
the display.
: Power button. Versiv 2: The LED in the power button
shows the status of the battery charging process. See Table 2
on page 18.
: Press to go to the home screen.
Connector for the ac adapter. Versiv: The LED is red when the
battery charges, and green when the battery is fully charged.
The LED is yellow if the battery will not charge. See “Charge
the Battery” on page 18.
RJ45 connector: Lets you connect to a network for access to
Fluke Networks cloud services.
Decal with laser
safety information:
To Next Page
Loading...
