Chapter 11: The OptiFiber Pro OTDR Module
Real Time Trace
375
Tap the settings you want. You can scroll some columns to see
more settings. Table 12 on page 312 gives descriptions of the
settings.
Select the wavelengths to use for the test.
The SAVE SETUP button lets you save your settings:
Active: The tester saves the settings in the active test setup, and
changes the active Test Type to Manual. This selection is not
available if the module selected in the active test setup does not
match the installed module.
New: The tester saves the settings in a new Manual test setup
that is added to the project. The tester uses the Manual setup
until you save the results or exit the results screen then start a
test from the home screen. Then the tester uses the test setup it
had before you changed the OTDR settings.
If you save your settings in a new test setup:
The tester uses your settings until you save the results or exit the
results screen then start a test from the home screen. Then the
tester uses the test setup it had before you changed the settings.
If you do not save your settings:
The tester uses your settings until you save the results or exit the
results screen then start a test from the home screen. Then the
tester uses the test setup it had before you changed the settings.
Tap RESUME or press to do a test with the settings you
selected.
To Next Page
Loading...
