Fluke DSX-8000 - Page 425

Chapter 11: The OptiFiber Pro OTDR Module
Bi-directional SmartLoop Tests
389
 The tester does not calculate averaged results in some
situations, for example if a launch, tail, or loopback cord was
not detected during a SmartLoop test, or if the distance to the
end was not the same in both directions.
GPU197.EPS
Figure 158. EventMap for Averaged, Bi-directional SmartLoop Results
 The purple fiber is the loopback cord.
 The longest segment length of the two directions.
 Tap this button to see the results for the other fiber (A or B).
Touch for 3 seconds to see a summary of the results from
ends 1 and 2 on fibers A and B. To see the EventMap for a result
in the list, tap the result.
A
B
I
G
C
D
F
H
E