Versiv Series Cabling Certification Product Family
Technical Reference Handbook
448
Note
The SAVE SETUP button does not show if the
wavelengths on the screen (
) are not available
in the active test setup. For example, the button
does not show if the OptiFiber Pro HDR OTDR is
module installed, but the active test setup is for an
OptiFiber Pro module.
Active: The tester saves the settings in the active test setup. If
the test was not a Manual test, the tester changes the active
Test Type to Manual.
New: The tester saves the settings in a new test setup that is
added to the project. The new setup is a Manual PON OTDR test
or a Manual OTDR test.
If you save your settings in a new test setup:
The tester uses your settings until you save the results or exit the
results screen then start a test from the home screen. Then the
tester uses the test setup it had before you changed the settings.
If you do not save your settings:
The tester uses your settings until you save the results or exit the
results screen then start a test from the home screen. Then the
tester uses the test setup it had before you changed the settings.
Tap TEST or press to do a test with the settings you
selected.
The PROGRESS screen shows Manual PON OTDR when the
tester uses your settings.
To Next Page
Loading...
