Versiv Series Cabling Certification Product Family
Technical Reference Handbook
450
dB/km or dB/kft = : Power loss (in decibels) that would
occur over 1 km (1000 m) or 1 kft (1000 ft) of fiber. The
tester uses the loss between the start and end of the
green measurement bar to calculate this value.
4 To make a new measurement, tap the yellow circle, tap
UNMARK (
), then do steps 1, 2, and 3 again.
GPU18.EPS
Figure 176. How to Use the Measurement Cursor on the ODTR Trace
To specify the start of a measurement, tap the yellow circle (),
then tap MARK.
To see the MARK and UNMARK buttons, tap the yellow circle.
To move the cursor in small increments, tap or press and hold
or . If these buttons do not show, tap the yellow circle
on the cursor.
To Next Page
Loading...
