Chapter 1: Get Acquainted
The HOME Screen
27
Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
Turn Auto Save on or off.
Select End 1 or End 2 for OTDR and FiberInspector tests
and loss/length tests in Far End Source mode.
Enter a name for End 1 and End 2.
Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names.
For each operator you can also enter the email address that the
operator will use as an ID to sign in to LinkWare Live.
To change the email address associated with an operator, select
the operator, then sign in to LinkWare Live with a different
address on the LWL SIGN IN screen. See Chapter 18.
TOOLS: The TOOLS menu lets you set up the compensation
function for the launch/tail cords, use tools such as the real-time
trace and the FiberInspector test, see the status of the tester, and
set user preferences such as the language and the display
brightness.
RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
SYNC: To upload test results to LinkWare Live, tap SYNC. See
Chapter 18.
TEST: Tap TEST to do the test shown in the test setup panel.
The percentage of the tests in the project that are completed.
The tester uses the number of available IDs and, for fiber tests,
the tests you selected on the CABLE ID SETUP screen to calculate
this percentage. See Figure 198 on page 526. % Tested does not
show if your project contains only a Next ID list. See “To Make ID
To Next Page
Loading...
