Fujitsu Eternus web GUI - Page 140

Chapter 7 Thin Provisioning Pool Management
7.1 Thin Provisioning Pool Status
ETERNUS Web GUI User’s Guide
140
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
The following items are displayed in the Main area:
• No.
The TPP number is displayed. Clicking this item displays the screen shown in "7.1.5 Thin
Provisioning Pool Detail (Basic)" (page 142).
• Name
The TPP name is displayed. Clicking this item displays the screen shown in "7.1.5 Thin
Provisioning Pool Detail (Basic)" (page 142).
• Disk Type
The type of drive that configures the TPP is displayed.
- Online:
SAS disks
- Nearline
Nearline SAS disks
- SSD
• RAID Type
The type of RAID group that configures the TPP is displayed.
- High Performance (RAID1+0)
- High Capacity (RAID5)
- High Reliability (RAID6)
- Mirroring (RAID1)
- Striping (RAID0)
• Status
The TPP status is displayed. Refer to "B.4 Thin Provisioning Pool Status" (page 615)
for
detailed information of TPP status.
• Total Capacity
The total capacity of TPP is displayed.
• ECO Mode Schedule
The ECO mode schedule that is assigned to the TPP is displayed.
If the ECO mode schedule is not assigned, the field is blank.
• Action
When the ECO mode is enabled in TPP, "ON" is displayed. If the ECO mode is disabled,
"OFF" is displayed.
If the ECO mode is not assigned, a "-" (hyphen) is displayed.
• Motor Status
The disk motor status for the TPP is displayed.
- Active
The disk motors are activated.
- In the Boot Process
The disk motors are starting up.
- Idle
The disk motors are stopped.
- In the Stop Process
The disk motors are being stopped.