ETERNUS Web GUI User’s Guide
31
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
Chapter 3 Initial Setup
This chapter describes the Initial Setup function for the ETERNUS DX Disk storage system.
This function performs the required initial settings that must be set before operating the
ETERNUS DX Disk storage system on a series of wizard screens.
Initial Setup is divided into "Initial Setup 1" and "Initial Setup 2".
• Initial Setup 1
Performs the minimum settings required before using the ETERNUS DX Disk storage system.
• Initial Setup 2
Makes the reporting settings for when an error occurs in the ETERNUS DX Disk storage
system. The settings can be omitted if the reporting function will not be used.
If the browser is shut down during execution of Initial Setup, other functions
will no longer be available. If this case, forcibly log in using the same user
name, and perform Initial Setup 1 again from the beginning. However, if you
have already reached Initial Setup 2, the wizard is executed from the
beginning of Initial Setup 2.
The settings made in the Initial Setup can be changed individually later.
To Next Page
Loading...