Fujitsu Eternus web GUI - Chapter 4 Configuration Settings; 4.1 Configuration Settings for Using Standard Volumes

ETERNUS Web GUI User’s Guide
54
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
Chapter 4 Configuration Settings
This chapter describes the following configuration settings:
• Configuration settings for using Standard volumes
• Configuration settings for using Thin Provisioning functions
4.1 Configuration Settings for Using Standard Volumes
The following section describes the series of settings when using Standard volumes.
Not only can new RAID groups be created, adding or changing volumes that are registered in
existing RAID groups can also be performed.
Create RAID Group
Create a RAID group (a group of drives that configures the RAID in the ETERNUS
DX Disk storage system
).
Refer to:
- Create RAID Group
Create Volume
Create a volume (drive area in the RAID group). A volume is a structural unit of RAID that
can be recognized from the server. Select "Standard" for "Type".
Refer to:
- Create Volume