Fujitsu Eternus web GUI - Page 174

Chapter 8 Advanced Copy Management
8.1 Advanced Copy Status
ETERNUS Web GUI User’s Guide
174
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
- Suspend
Suspended by an instruction from the host
- Error Suspend
Copy canceled due to an error
• Phase
The copy session phase is displayed. If the status is "Reserve", a "-" (hyphen) is displayed.
- Copying
EC, Monitor, REC: Copying
For QuickOPC: Copying the updated areas after recording of updated areas is stopped
- Equivalent
Maintaining equivalent status of the copy source and copy destination that are duplicated
after copy is complete
- Tracking
Recording only the updated area after copy is complete
- Tracking & Copy
Recording the area updated during copy processing and after copy starts
- No Pair
No pair of duplicated copy source and copy destination is set
• Error Code
The error code is displayed when an error occurs. If the status is "Reserve", a "-" (hyphen) is
displayed.
• Time Stamp
The time when backup is complete and the time when an error occurred are displayed. If the
status is "Reserve", a "-" (hyphen) is displayed.
The time stamp is updated in the following conditions:
- For OPC, QuickOPC, SnapOPC, and SnapOPC+
Copy start time is used as the backup completion time. The time stamp is updated when
copy starts and when an error occurs.
• When the "Status" is "Active", the previous backup time is displayed.
• When the "Status" is "Error", the time when an error occurred is displayed.
For QuickOPC, the time stamp is updated also at restart.
- For EC
Suspend time is used as the backup completion time. The time stamp is updated at
Suspend and when an error occurs.
• When the "Status" is "Suspend", the previous backup time is displayed.
• When the "Status" is "Error", the time when an error occurred is displayed.
- For Monitor
Time stamp is not displayed.
• Elapsed Time
The elapsed time after a session starts is displayed. If the status is "Reserve", a "-" (hyphen)
is displayed.
• Copied Data Size
The size of copy that has been complete is displayed. If the status is "Reserve", a "-" (hyphen)
is displayed.
• Total Data Size
The total copy size is displayed. If the status is "Reserve", a "-" (hyphen) is displayed.