Fujitsu Eternus web GUI - Page 301

Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
301
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
The procedure to create an iSCSI host group is as follows:
Procedure
1 Click [Add iSCSI Host] in [Action].
2 Enter a host group name to be created, and select a host response to be
assigned to the host group.
• iSCSI Host Group Name
Specify the host group name.
An existing host group name cannot be specified. Refer to "Naming conventions for
adding iSCSI hosts" (page 619) for details.
The following input conditions apply:
- 1 - 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Space
• Host Response
Select a host response to be assigned to a host group.
The host response list created in the ETERNUS DX Disk storage system is displayed.
- Windows EMPD (*1)
- Linux EMPD (*1)
- Solaris EMPD (*1)
- Solaris MPxIO
- HP-UX
- AIX EMPD (*1)
- AIX VxVM
- AIX Single Path
- VS850/SVC
- Host responses created in the ETERNUS DX Disk storage system
- Others
*1: EMPD: ETERNUS Multipath Driver
• Registration of the host is necessary to create a host group. Create a
new host group when registering a host on GUI.
• One host cannot be a member of several host groups.
• Assign an appropriate host response to the created host group. The
host response configures the operation mode which is appropriate to
the host.
If an appropriate host response is not configured to the host group, the
path may not be switched correctly or the volume may not be
recognized correctly.
• To change the settings of the host groups, refer to "9.2.2.5 Modify Host
Group" (page 312).
• To add a port to an existing host group, refer to "9.2.2.5 Modify Host
Group" (page 312).
• To change the host group names, refer to "9.2.2.13 Rename iSCSI
Host" (page 335).