Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
324
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
4 Click the [OK] button.
→ Modification of the iSCSI host group starts.
5 Click the [Done] button to return to the [Host Group] screen.
9.2.2.8 Modify SAS Host Group
This function performs the following modifications to the existing SAS host group.
• Host Group Name
• Host Response
• Number of Hosts (Add and delete member hosts in a host group)
An error screen appears in the following conditions:
• When the "Host Group Name" overlaps with an existing host
group name (Host group names cannot overlap with any other
host group names, irrespective of the interface types.))
• When the total number of hosts has exceeded the maximum
number for the device
• When no hosts are registered in a host group, or when nine or
more hosts are registered in a host group
• When the specified host has already been registered in another
host group
• When several iSCSI hosts with the same "IP Address" and "iSCSI
Name" have been configured
• When several iSCSI hosts are specified with the same "iSCSI
Name" and no IP addresses are specified
• When the specified iSCSI name is already registered in the
ETERNUS DX Disk storage system
• When the several iSCSI hosts with the same iSCSI name have
been registered
• When the specified host response does not exist in the
ETERNUS DX Disk storage system
To Next Page