Fujitsu Eternus web GUI - Page 433

Chapter 10 Component Management
10.2 Functions in the Action Area for Component
ETERNUS Web GUI User’s Guide
433
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
2 Click the [OK] button.
→ The LED of the enclosure is turned on.
3 Click the [Done] button to return to the [Controller Enclosure] screen.
End of procedure
■ Turning off the LED
The procedure to turn off an LED is as follows:
Procedure
1 Click [Turn off locator beacon] in [Action].
→ A confirmation screen appears.
2 Click the [OK] button.
→ The LED of the enclosure is turned off.
3 Click the [Done] button to return to the [Controller Enclosure] screen.
End of procedure
If the LED is already turned off, [Turn off locator beacon] cannot be
selected.