Fujitsu Eternus web GUI

To Next Page

To Previous Page

Chapter 11 System Management

11.2 Functions in the Action Area for System

ETERNUS Web GUI User’s Guide

554

• Temperature restoration

Select whether to notify when a temperature error or warning status is recovered to the

normal status. When notifying, select the notification method.

• User login/logout

Select whether to notify when a User login/logout is detected. When notifying, select

the notification method.

• Operated RAID Group

Select whether to notify when the RAID group has been created or deleted. When noti-

fying, select the notification method.

• Added/Released Hot Spare

Select whether to notify when the hot spare disk has been registered or released.

When notifying, select the notification method.

• Operated Volume

Select whether to notify when the volume has been created or deleted. When notifying,

select the notification method.

• Power off/on CFL

Select whether to notify when the ETERNUS DX Disk storage system is turned off/on

or when the controller firmware is changed in hot mode. When notifying, select the noti-

fication method.

• SDP Usage Rate Over Lv1

Select whether to notify when an SDP Policy Level 1 (Informational) event occurs.

When notifying, select the notification method.

• SDP Usage Rate Over Lv2

Select whether to notify when an SDP Policy Level 2 (Warning) event occurs. When

notifying, select the notification method.

• SDP Usage Rate Over Lv3

Select whether to notify when an SDP Policy Level 3 (Error) event occurs. When notify-

ing, select the notification method.

• Copy Table Size Usage Rate Over

Select whether to notify when the copy table usage exceeds the threshold. When noti-

fying, select the notification method.

• Trial copy license expired

Select whether to notify when a copy trial license expiration event occurs. When notify-

ing, select the notification method.

• Threshold of SDP usage can be specified using the procedure in

"8.2.7 Modify Copy Parameters" (page 215)

• Threshold of copy table size usage can be specified using the

procedure in "8.2.6 Modify Copy Table Size" (page 207)

Fujitsu Eternus web GUI - Page 554