6.2.2.3 Replacing SFP+ transceiver modules
Removing SFP+ transceiver modules
Ê Remove the defective SFP+ transceiver module(s) as described in section
"Removing an SFP+ transceiver module" on page 103.
Installing SFP+ transceiver modules
Ê Unpack the new SFP+ transceiver module.
Ê Verify that the new SFP+ transceiver module is the same type of transceiver
you are replacing.
Ê Install the new SFP+ transceiver module(s) as described in section
"Installing SFP+ transceiver modules" on page 98.
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 80.
I By replacing SFP+ transceiver modules, WWN (World Wide Name)
and MAC (Media Access Control) addresses will change.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less
To Next Page
Loading...
Need help?
General