Installing processors on the new system board
Ê "Installing the processor" on page 137.
Installing protective socket covers on the defective system board
I Since the defective system board is sent back for repair, protect the
delicate processor socket springs with a socket cover.
Ê "Installing the processor" on page 137
9.5.2.4 Completing the system board
Ê "Installing the riser module" on page 43
Ê "Installing the UFM board" on page 165 (if applicable)
Ê "Installing the SATA DOM board" on page 153 (if applicable)
Ê "Installing the iRMC microSD card" on page 175 (if applicable)
Ê Install all expansion cards as described in chapter "Expansion cards" on
page 91 (if applicable)
I Install the expansion cards into their original slots.
Ê "Installing a memory module" on page 122
I Install the memory modules into their original slots.
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section "Cabling overview" on page 206.
9.5.3 Concluding steps
Perform the following steps:
Ê "Installing the server node in the server enclosure" on page 50
Ê If applicable, reconnect all external cables.
Ê "Controls and indicators on the server node" on page 51
Ê "Verifying system information backup / restore" on page 67
To Next Page
Loading...
Need help?
General