7.2.3 Concluding steps
Perform the following procedures:
Ê "Installing the memory slot air ducts" on page 49
Ê Connect the SATA cable(s) to the connectors on the system board described
in section "Cabling for HDD 2.5"" on page 208 and reroute the cables as
described in section "Cabling onboard" on page 208 or "Cabling with RAID-
Controller" on page 209.
Ê Identify the correct memory slot according to the mounting order described
in section "Memory sequence" on page 118.
Ê "Installing the server node in the server enclosure" on page 50
Ê If applicable, reconnect all external cables.
Ê "Controls and indicators on the server node" on page 51
Ê "Updating or recovering the system board BIOS and iRMC" on page 61 (if
applicable)
Ê "Verifying the memory mode" on page 74 (if applicable)
Ê "Resetting the error status after replacing memory modules or processors"
on page 86
To Next Page
Loading...
Need help?
General