9.3 USB Flash Module (UFM)
The server node can be equipped with a USB Flash Module (UFM).
9.3.1 Installing the UFM board
9.3.1.1 Required tools
– Preliminary and concluding steps: tool-less
– Main steps:
– Phillips PH1 / (+) No. 1 screw driver
9.3.1.2 Preliminary steps
Perform the following procedures:
Ê "Disabling SVOM boot watchdog functionality" on page 54
Ê Locate the desired server with the ID button.
Ê "Shutting down the server node" on page 39
Ê If applicable, remove all external cables from the server node.
Ê "Removing the server node from the server enclosure" on page 40
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: – Preliminary and concluding steps: tool-less
– Main steps:
– Phillips PH1 / (+) No. 1 screw driver
To Next Page
Loading...
