Fujitsu PRIMERGY CX2550 M1 - Tools You Need at Hand

CX2550 M1 Upgrade and Maintenance Manual 23
Before you start
2.3 Tools you need at hand
When preparing the maintenance task, ensure that all required tools are
available according to the overview below. You will find a list of required tools at
the beginning of each procedure.
Screw driver /
Bit insert
Screw Usage Type
Phillips
PH1 / (+) No. 1
UFM / SATA
DOM nylon
screw
M3 x 4.5 mm
(white)
A3C40109082
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
Network
controller
M3 x 4.5 mm
C26192-Y10-C67
hexagonal cross
SW5
System board
M3 x 4.5 mm
C26192-Y10-C67
Table 2: List of required tools and used screws