EasyManua.ls Logo

Fujitsu PRIMERGY CX2550 M1 - Installing an Expansion Card; Concluding Steps

Fujitsu PRIMERGY CX2550 M1
222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CX2550 M1 Upgrade and Maintenance Manual 113
Expansion cards
6.3.3.3 Installing an expansion card
Ê If applicable, install a slot bracket on the new expansion card as described
in section "Mounting expansion card slot brackets" on page 95.
Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card, as described in section "Installing SFP+ transceiver modules" on
page 98.
Ê Install the new expansion card as described in section "Mounting a controller
to the riser module" on page 109.
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "Cabling
overview" on page 206.
6.3.3.4 Concluding steps
Perform the following procedures:
Ê "Installing the riser module" on page 43
Ê "Installing the server node in the server enclosure" on page 50
Ê Reconnect all external cables.
Ê "Controls and indicators on the server node" on page 51
Ê "Updating RAID controller firmware" on page 67 (if applicable)
Ê "After replacing / upgrading LAN controllers" on page 83 (if applicable)
Ê "Updating the NIC configuration file in a Linux environment" on page 77
Ê "Looking up changed MAC / WWN addresses" on page 80

Table of Contents

Other manuals for Fujitsu PRIMERGY CX2550 M1

Related product manuals