Figure 66: Installing the UFM board (B)
Ê The UFM module on the plastic spacer must audibly click into place (see
arrow).
9.3.1.4 Concluding steps
Perform the following procedures:
Ê "Installing the server node in the server enclosure" on page 50
Ê If applicable, reconnect all external cables.
Ê "Controls and indicators on the server node" on page 51
9.3.1.5 Software configuration
In order to setup the ESXi configuration, the VMware ESXi Recovery Tools CD
is required. An ISO image of the CD is available from the Fujitsu service
partners portal at the following https address:
https://globalpartners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/
Pages/default.aspx.
Ê Sign in and choose your PRIMERGY server.
Ê Select the Software & Tools Documentation category.
To Next Page
Loading...
Need help?
General