9.3.3.3 Re-installing the UFM
Ê Connect the UFM board to the system board and secure the UFM module
on the UFM spacer with the nylon screw as described in "Installing the UFM
board" on page 165.
Destroying the defective UFM board
V CAUTION!
The UFM board contains customer information (e.g. IP address, license
numbers). After replacing the UFM, hand the defective UFM board over
to the customer. If the customer requests disposal of the defective UFM
board, proceed as follows:
Figure 69: Destroying the defective UFM board
Ê Use a pair of combination pliers (1) and flat nose pliers (2) to break
the UFM board in half as shown.
9.3.3.4 Concluding steps
Perform the following procedures:
Ê "Installing the server node in the server enclosure" on page 50
To Next Page
Loading...
Need help?
General