8.3.4 Concluding steps
Perform the following steps:
Ê "Installing the server node in the server enclosure" on page 50
I If the Global LED is flashing with error message "CPU has been
changed" on display after the system is powered on, please follow the
procedure below.
Ê Restart the system and wait until the screen output appears.
Ê Press the [F2] function key.
Ê If a password is assigned, enter this password and confirm with the
[Enter] key.
The BIOS setup Main menu will be displayed on the screen.
Ê Select "Save Changes and Exit" or "Save Changes and Reset" on
Save & Exit menu.
Ê Confirm LED no flashing.
This information is only regarding to the change of CPU configuration.
There is no technical problem.
– "Updating or recovering the system board BIOS and iRMC" on page 61 (if
applicable)
– "Controls and indicators on the server node" on page 51
– "Resetting the error status after replacing memory modules or processors"
on page 86
– "Enabling SVOM boot watchdog functionality" on page 72
To Next Page
Loading...
Need help?
General