10.2.1.1 Adhesive rules for the memory cooling pads
Memory modules 1A, 1C, 1E, 1G
Figure 98: Memory modules 1A, 1C, 1E, 1G: joining face for the cooling pad
The cooling pad must be stuck on the above shown side of the memory module.
Memory modules 2B, 2D, 2H, 2F
Figure 99: Memory modules 2B, 2D, 2H, 2F: joining face for the cooling pad
The cooling pad must be stuck on the above shown side of the memory module.
Memory modules 1B, 1D, 1F, 1H, 2A, 2C, 2E, 2G
The cooling pads must be stuck on both sides of the memory module.
To Next Page
Loading...
