Ê Install the memory modules as described in section "Installing a memory
module" on page 122
Ê "Installing a liquid cooling kit" on page 192
Ê "Installing the server node in the server enclosure" on page 50
I If the Global LED is flashing with error message "CPU has been
changed" on display after the system is powered on, please follow the
procedure below.
Ê Restart the system and wait until the screen output appears.
Ê Press the [F2] function key.
Ê If a password is assigned, enter this password and confirm with the
[Enter] key.
The BIOS setup Main menu will be displayed on the screen.
Ê Select "Save Changes and Exit" or "Save Changes and Reset" on
Save & Exit menu.
Ê Confirm LED no flashing.
This information is only regarding to the change of CPU configuration.
There is no technical problem.
Ê "Updating or recovering the system board BIOS and iRMC" on page 61 (if
applicable)
Ê "Controls and indicators on the server node" on page 51
Ê "Enabling SVOM boot watchdog functionality" on page 72
To Next Page
Loading...
