Chapter 4 FRU Replacement Preparation 4-5
Caution – If you use the PCI Hot Plug (PHP) function on the servers with Oracle
Solaris 10 9/10, or 142909-17 or later, enable the hotplug service as follows:
# svcadm enable hotplug
2. Type the cfgadm command to disconnect the component from the domain:
Note – For a PCI cassette, type the cfgadm -c disconnect command to
disconnect the component from the domain.
The Ap_Id is shown in the output of cfgadm.
iou#0-pci#0 for example.
3. Type the cfgadm command to confirm the component is now disconnected.
4.2.2 Removing and Replacing a FRU
Once the FRU has been removed from the domain, see Section 4.3.1, “Removing and
Replacing a FRU” on page 4-7
4.2.3 Adding a FRU Into a Domain
1. From the Oracle Solaris prompt, type the cfgadm command to connect the
component to the domain.
The Ap_Id is shown in the output of cfgadm.
iou#0-pci#0 for example.
# cfgadm -c unconfigure Ap_Id
# cfgadm -a
Ap_Id Type Receptacle Occupant
Condition
iou#0-pci#0 etherne/hp disconnected unconfigured
unknown
iou#0-pci#1 fibre/hp connected configured ok
iou#0-pci#2 pci-pci/hp connected configured ok
# cfgadm -c configure Ap_Id
To Next Page
Loading...
