Fujitsu SPARC Enterprise M5000 - Sliding the Server out of the Equipment Rack

5-2 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
5.1.1 Sliding the Server Out of the Equipment Rack
Caution – To prevent the equipment rack from tipping over, you must deploy the
antitilt feature, if applicable, before you slide the server out of the equipment rack.
Note – When drawing out the SPARC Enterprise M4000/M5000 Server to the front,
release the cable tie holding the PCI cables on the rear of the server.
Caution – Use proper ESD grounding techniques when handling components. See
Section 1.1, “Safety Precautions” on page 1-1.
1. Deploy the rack’s antitilt features (if applicable).
Refer to the manual that shipped with the rack for details on antitilt features.
2. If shipping brackets are attached to the back of the server, loosen the four (4)
captive screws (FIGURE 5-1).