Chapter 6 Storage Devices Replacement 6-5
6.1.3 Installing the Hard Disk Drive
Caution – Do not force the hard disk drive into the slot. Doing so can cause damage
to the component and server.
1. Pull the latch so that it is straight out from the drive.
2. Align the drive in the slot and push it gently into position until it stops.
3. Secure the latch.
6.1.4 Securing the Server
1. Add the hard disk drive to the domain.
This step includes using the cfgadm command to connect and confirm the hard
disk drive has been added to the domain. See Section 4.2.3, “Adding a FRU Into a
Domain” on page 4-5.
2. Verify the state of the status LEDs on the hard disk drive.
To Next Page
Loading...
Need help?
General