6-26 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
6.3.1 Accessing the Tape Drive Unit
● Remove the tape drive unit from the domain.
This step includes using the cfgadm command to determine the Ap_Id and
disconnecting the tape drive. See Section 4.2.1, “Removing a FRU From a Domain”
on page 4-4.
6.3.2 Removing the Tape Drive Unit
Caution – Use proper ESD grounding techniques when handling components. See
Section 1.1, “Safety Precautions” on page 1-1.
1. Put a No. 1 screwdriver into the tape drive unit release hole to release the catch
that holds the tape drive unit in place (
FIGURE 6-10).
2. Remove the drive from the server and place it on the ESD mat.
FIGURE 6-10 Removing the Tape Drive
To Next Page
Loading...
