Chapter 2 Fault Isolation 2-21
2.6 Using the Diagnostic Commands
After the message in TABLE 2-7 is displayed, you might desire more information about
the fault. For complete information about troubleshooting commands, refer to the
Oracle Solaris 10 man pages or the XSCF Shell man pages. This section describes
some details of the following commands:
■ showlogs
■ fmdump
■ fmadm
■ fmstat
2.6.1 Using the showlogs Command
The showlogs command displays the contents of a specified log in order of time
stamp starting with the oldest date. The showlogs command displays the following
logs:
■ error log
■ power log
■ event log
■ temperature and humidity record
■ monitoring message log
■ console message log
■ panic message log
■ IPL message log
An example of the showlogs output.
XSCF> showlogs error
Date: Oct 03 17:23:11 UTC 2006 Code: 80002000-ccff0000-0104340100000000
Status: Alarm Occurred: Oct 03 17:23:10.868 UTC 2006
FRU: /FAN_A#0
Msg: Abnormal FAN rotation speed. Insufficient rotation
XSCF>
To Next Page
Loading...
