GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-41
3-5-3-8 Mounting small Peripherals (e.g., Black & White Printer)
1.) Screw out the screws of the leveling feet from the printer.
2.) Mount the adapter board with the 4 screws on the printer (leveling feet are also mounted).
NOTE: Pay attention to the right mounting position of the printer.
3.) Put the pre-assembled Printer on the Console Bottom Shelf.
4.) Place the locking teeth of the adapter board into the guide slots of the shelf and move the Printer in
the final mounting position.
5.) Mount the adapter board with 1 screw on the Console Bottom Shelf (see Figure 3-50, above).
6.) Connect the peripheral device and mount the pull out protection of the power cable.
Links to connection schemes can be found in Table 3-9, “Connection Procedures,” on page 3-23.
7.) Place the Cover BW Printer Shelf at its original position.
Figure 3-49 screw of the 4 screws / mount the adapter board
Figure 3-50 put the pre-assembled Printer on the Shelf / mount the adapter board
Figure 3-51 Connect peripheral device to the Voluson Station
Connect B/W printer
or Color printer
Connect Power
Distribution
To Next Page
Loading...
