GE Voluson i BT06 - Voluson I; Voluson E Mounted on Modo Cart

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-56 Section 3-5 - Connection of Auxiliary Devices
3-5-13-1 Direct Connection to the Voluson i / Voluson e system (cont’d)
1.) Connect one end of the VGA cable to SVGA OUT located on the Voluson i / Voluson e rear
connector panel.
2.) Connect the other end of the VGA cable to RGB IN on the video converter.
3.) Connect one end of the S-Video cable to S-VIDEO OUT on the video converter.
4.) Connect the other end of the S-Video cable to S-VIDEO IN at the rear of the VCR.
Figure 3-70 Connection Scheme - VCR with Video Scan Converter Ophit
CAUTION
!! CAUTION:
When connecting the VCR/Video Converter directly to the system, it is necessary to use an additional
power source. As a safety requirement, the VCR internal AC/DC and the Video Converter AC/DC
(supplied with the Video Converter) must be medical grade (conforming 60601-1 standard) or
the safety must be ensured by the use of a medical grade isolation transformer.
NOTICE
!! NOTICE:
Auxiliary equipment with direct mains connection requires galvanic separation e.g. by use of a medical
grade isolation transformer.
Power
Video Converter (rear)
Supply
Video Converter (front)
power
socket
Voluson i/e (rear)
Isolation Transformer