GE Voluson i BT06 - Calculations; Worksheet (Report)

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
4-24 Section 4-4 - Functional Checks
4-4-8 Calculations
The Voluson i / Voluson e system supports calculation packages and application-oriented patient
Worksheets (Reports) for following applications:
• Abdomen Calculations
• Small Parts Calculations
• Obstetric Calculations
• Cardiology Calculations
• Urology Calculations
• Vascular Calculations
• Gynecology Calculations
• Pediatric Calculations
• Neurology Calculations
• Orthopedics Calculations
NOTE: Confirm that the patient information is correct and the probe and application are selected properly.
NOTE: Different menus are displayed depending on:
• the currently chosen Application
• the selected Display Mode,
• the selected “Study”,
• and the settings in the Measure Setup -
MEASURE & CALC page.
For further details refer to the Voluson i / Voluson e Basic User Manual, Chapter 13
4-4-8-1 Worksheet (Report) Pages
General remarks to perform Calculations:
• By pressing the CALC
key on the control panel the Calculation function is switched on.
• Selection of the desired measurement marks is done with the MENU POINTER
[Cursor] key and the
trackball, or by pressing the corresponding keyboard shortcuts.
• If the MENU POINTER
[Cursor] key (nearby the trackball) is illuminated, the trackball is consequently
assigned to select the menu items in the menu area on the left side of the screen.
• Positioning of measurement marks is done with the TRACKBALL
.
• Entering and storage of measuring marks is done with
SET (right or left trackball key).
• To change measuring marks before completion press
CHANGE (upper trackball key).
• Depending on the setting in the Measure Setup, also the FREEZE
key can be used for confirming the
last measuring mark of the currently performed measurement.
• To delete the results of the last measured item, press BACKSPACE
.
• To erase measurement results, press the CLEAR
key on the control panel or press the DEL key on
the keyboard.
• All measurement results will be automatically included in the patient report worksheet.
• To delete all measurement results of the selected “Study” from the monitor as well as from the
corresponding Worksheet, select the CLEAR GROUP
item from the menu area.
• To exit from Calculation functions, press the CALC
key or the EXIT key on the control panel.
Press the REPORT
key on the control panel to view the “application dependent” patient worksheet
pages that contain the results of calculations and measurements. Any stored patient worksheet can be
edited, printed, transferred, saved to Sonoview or sent to DICOM® server.