GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-51
8-19-7 Replacement of the Fuses
NOTE: Change Main Power Voltage and change fuses of Power Supply is the same procedure for the Power
Supply of the Dock Cart and the Power Supply of the Voluson Station.
8-19-7-1 Manpower
One person, 10 minutes
8-19-7-2 Tools
Phillips screwdriver 1
8-19-7-3 Preparation
1.) Power Off/Shutdown the system as described in Section 3-6-3 on page 3-72.
8-19-7-4 Fuses - Removal Procedure
1.) Open the fuse protection on the rear of the Power Supply.
2.) Pull out the fuse holder and remove the 2 fuses.
8-19-7-5 Fuses - Installation Procedure
1.) Insert 2 new fuses.
2.) Push the fuse holder back into position (correct voltage should be shown) and then close protection.
Figure 8-69 opern the fuse protection
Figure 8-70 change Main Power Voltage / change fuses of power supply
Fuse holder
(e.g. 230V)
Fuses
Fuse Holder
To Next Page
Loading...
