GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-47
3-5-7-1 Connection directly to the Voluson i / Voluson e system (cont’d)
NOTE: The power switch on the rear of the DVD drive (Addonics only) must be set in the External position, as
shown below:
The DVD+R/RW Drive can be connected once the system is powered ON, or after shutdown.
NOTE: When connecting the DVD+R/RW Drive to the Voluson i / Voluson e system, it might be possible that
the Drive is not recognized in the “Connect USB and Network Drives” dialog window.
To check connection, perform: Section 3-5-7-5-1 "After physical connection" on page 3-48.
3-5-7-2 Connection via USB hub
As stated above.
Safety considerations must be taken into account.
The USB hub and the DVD+R/RW Drive must be powered via an isolation transformer.
An USB port may be used to communicate with the DVD device.
3-5-7-3 Voluson i / Voluson e mounted on Modo Cart
The DVD+R/RW Drive may be connected to the USB ports on the rear of the Voluson i / Voluson e.
A power cable that extends from the power outlets of the Modo Carts isolation transformer should be
used to connect the power supply of the DVD+R/RW drive.
The DVD+R/RW can be placed in the upper peripheral storage shelf on the Modo Cart (refer to Figure
3-10 on page 3-14). The power cable (described above) is then plugged into the rear of the DVD device
and the data cable is connected to the USB port.
3-5-7-4 Voluson i / Voluson e mounted on Dock Cart
The DVD+R/RW Drive may be connected to the USB ports on the rear of the Voluson i / Voluson e.
A power cable that extends from the power outlets of the Dock Carts power supply should be used to
connect the power supply of the DVD+R/RW drive.
The DVD+R/RW should be placed in the Tray Recorder on the Dock Cart (refer to Figure 3-12 on page
3-16). The power cable (described above) is then plugged into the rear of the DVD device and the data
cable is connected to the USB port.
3-5-7-5 Voluson i / Voluson e mounted on Voluson Station
The DVD+R/RW Drive is premounted on the Voluson Station.
!! CAUTION:
When connecting directly to the system, it is necessary to use additional power supply (supplied with
the drive). As a safety requirement, this must be done via an isolation transformer.
!! NOTICE:
IMPORTANT During software installation, the DVD drive must be connected directly to the
Voluson i / Voluson e portable ultrasound system.
ExternalPower OFFInternal
To Next Page
Loading...
